ORAJET® 3628

When installing your graphic, always apply the material using a dry application method; under no circumstances should a wet  application be used. Also be careful when using a heat source during installation as this can cause the material to warp and not  register during panel installations.

Lay the graphic, image-side down, on a flat surface and pull back the liner about 3 inches. Sharply crease the liner while holding  it away from the adhesive. Align the graphic on the wall and use finger pressure to tack in place.

Using a Squeegee, work from the center to the edge, then return to the center and work to the opposite edge. Use overlapping strokes while applying a small portion of the graphic at a time. If your graphic is made up of more than one panel, avoid using  horizontal seams when possible.

When the entire graphic has been applied to the wall, reapply pressure with the Squeegee around the edges of the graphic multiple times to ensure a good bond. (If the graphic will come into contact with regular cleanings, such as mopping, soil removal, etc.,  graphics should be sealed in those areas This is especially important where the graphic is terminated at the floor. Use of a clear  silicone sealant along the edges of the graphic is recommended.)